| To: | "Datsun Club" <datsun-roadsters@autox.team.net> |
|---|---|
| Subject: | Front end |
| From: | "Jim Svedise" <svedise@hotmail.com> |
| Date: | Sun, 21 Mar 2004 09:45:40 -0800 |
Hi all, I need some help does anybody know what grade bolts and thread size we should use on the upper aframes?? I have to get longer ones to get the right amount of shims in to aline front end. I am guessing grade 10 (the higher the number the stronger the bolt??). Thanks in advance, Jim 70 2000 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Starters, Chains and Water pump motors, Andy Cost |
|---|---|
| Next by Date: | calibrating Temp Gauge, J Sylvester |
| Previous by Thread: | U20 Crank Shaft Diameter, stebharvey |
| Next by Thread: | Re: Front end, Marc&Heidi |
| Indexes: | [Date] [Thread] [Top] [All Lists] |