Thanks for the links to Gordon Glasgow's and roadster.org websites for the
valve clearance specs. Now our machinist needs the specs to set the cam.
Link, source, factory service manual? (I'm not exactly sure what he needs,
but assume it's the specs for where to set the cam in relation to the
pistons. Is that called degreeing the cam? He left me a message and I can't
get in direct touch with him at the moment)
Any help would be most appreciated as the little red bull dog has been
sitting since last October and we're both itching to get her back on the
road ASAP and this is the last holdup.
Thanks again for past and future help. I just love being connected to the
community.
Alex Avery
PS, my 280Z is about ready for paint, then reinstalling everything and
hooking the new high-compression engine up with an SDS ignition (have yet
to buy. Better lay out the $$ for that before my wife shuts the vault on
the finances!)
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|