Greetings,
I am installing an exhaust gas temperature gauge into my 67.5 stroked
1600. This involves drilling a 3/16" hole in my header to enstall a
clamp style thermocouple that inserts into and clamps around the drilled
hole. My question is....the gauge manufacturer states I should install
the thermocouple into the "leanest cylinder as defined by the engine
manufacturer". I don't have a clue. I suspect that with cylinder #1
being closest to the water pump and #4 being closest to the fire wall
that # 4 would be the leanest. That is my guess. Oh, I also have a
solex set up on this puppy. As always, any suggestions will be
appreciated.
Guy
67.5 stroker project
Tempe, AZ
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|