>Guy Wrote - What does a fellow do in this situation? Remove the current
studs and install longer ones that will enable both the back plate and the
horns to be mounted to the carbs? Cut off the flange that sticks out from
the
back plate and mount the horns flush to the plate surface? Other options?
Those "sheet metal extensions" are actually the stock air horns. No other
air is needed. The 6mm nuts that hold the cleaner back plate to the carbs
are trapped under them. To install, start each nut, with a split lock
washer, with just a couple of threads. Once you've got the all started,
tighten them down to finger tight then wrench tight. A 10mm crows foot
wrench is need to tighten the lower ones without pain.
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|