Hi list,
If any of you have seen the "repairs" done to the firewall of my 65
SP310, you would understand that I am designing a firewall brace for
both the brake and clutch master cylinder mounts.
see www.imagestation.com/album/?id=4291195515
At the risk of reinventing the wheel, could someone point me to a
picture or describe the Stan Brace?
I have decided to make a concession to originality in this area
because it is obviously a design fault.
My daughters 1990 Nissan Pulsar GTiR has the same design flaw!
Thanks in advance.
Regards,
Graeme Suckling
1965 SP310 - under construction
1971 P510 4 door - daily driver, original owner
1972 P510 2 door - in storage
1973 HS30/240Z - re-building
-----Original Message-----
From: owner-datsun-roadsters@autox.team.net
[mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of
Tomet9@aol.com
Sent: Saturday, 16 November 2002 6:44 AM
To: datsun-roadsters@autox.team.net
Cc: Tomet9@aol.com
Subject: Re: Gary Boone's EI
Hi List,
Ok here goes another plug for Gary Boone's electronic distributor
conversion. It's all that it is cranked up to be, virtually the
easiest of
installation w/Gary's thorough instructions.I am running a Jacobs
Energy coil
with it and the car just seems to have a little more pizzaz thru out
the
entire rpm range
I have not put a whole lot of money into this car since aquiring it
but of
all the things I have purchased, I must say the three best investments
ever
made would be a 2 inch exhaust (mini turbo muffler & glass pack)
Stans
firewall brake brace and Gary Boones EI.
You all got a get one of these, a definite must have item.
Thanks Gary,
Tom Prather 2.0 Lady in red
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|