snyler wrote:
> Is there a handy dandy trick to removing and replacing the throwout
> bearing onto its carrier (using stone knives and bear skins, of course).
> Would I be advised to have a shop do the replacing?
>
Marc,
If you have the engine and transmission out of the car, with the
TO bearing in your hand, take it to a machine shop for them
to press the old bearing off the bearing sleeve. They will probably
have a minimum charge to press off the old and then press on the
new one. Have the new bearing ready to put back on the sleeve.
Shouldn't take then even a half hour. Cost is probably
$10 to $20 as a guess. You probably wouldn't get it apart without
a press though.
Bob
67.5
Moscow
///
/// datsun-roadsters@autox.team.net mailing list
///
|