I didn't get the part number, but based on Sidney's recommendation may
pick it up and have another machine shop swap the pulley "thingies".
If I do, I'll give you the part number.
Adam
--- "Patrick J. Horne" <horne@cs.utexas.edu> wrote:
> What is the part number for the H20 water pump?
>
> Peace,
> Pat
>
> - Support Habitat for Humanity, A "hand up", not a "hand out" -
>
> Pat Horne, Network Manager, Shop Supervisor, Future planner
> CS Dept, University of Texas, Austin, Tx. 78712 USA
> voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
>
> On Fri, 27 Jul 2001, Adam Bradley wrote:
>
> > Well, after my recent repairs/alternator relocation my water pump
> > started leaking, and I thought it was from the gaskets in front of
> and
> > behind the water pump spacer, so I pulled it all apart, cleaned it,
> and
> > put it back together. Now it is leaking worse than before and I
> think
> > it's coming from the shaft, not the gaskets. There is also a mild
> > clanking noise coming from the water pump. Time for another $110
> water
> > pump...
> >
> > Anyway, I stopped by my local Nissan forklift dealer and they do
> have
> > the H20 water pump (Nissan brand) for $66, with all the correct
> holes
> > in the backing plate, and the casting is an exact match (although
> there
> > is some different writing/etc. in the casting), BUT the pulley
> mounts
> > differently, probably more like the early R16. They offered to
> swap
> > the pressed-on piece (what do you call that?) but at $58/hour, it
> would
> > cost as much as or more than an R16 water pump. Oh well.
> >
> > =====
> > Adam
> > '70 1600 SPL311-28181
> > http://www.picturetrail.com/abend
> > Make international calls for as low as $.04/minute with Yahoo!
> Messenger
> > http://phonecard.yahoo.com/
=====
Adam
'70 1600 SPL311-28181
http://www.picturetrail.com/abend
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/
|