In a message dated 5/28/2001 8:50:22 AM Pacific Daylight Time,
twalter@austin.rr.com writes:
> Did you see those two little alignment rings that
> fit into a couple of bolt holes? Replace them into
> the block
>
when i took mine apart, i saw no alignment rings. where are they supposed to
be? also, i have sent a picture and part number of the head gasket and
everyone said it was the right one. however, today i noticed something
different about the two. the section where the push rods go through the top
of the block it one hole for both rods of the same cylinder, but not on the
new gasket, the middle between the rods of the same cylinder is blocked off.
is this ok? i hadn't noticed it before........Chris
|