The 2L starter is 6.5" long from the outer flange (where the bolt heads
are). If you don't have that then spend a few more $$ and buy a gear
reduction starter as it's much smaller and more powerful. TS Automotive
sells them for 225. If I didn't have a few new starter motors sitting on my
shelf I would have bought one for my stroker.
Mike
----- Original Message -----
From: <KJCMFCC@aol.com>
To: <datsun-roadsters@autox.team.net>
Sent: Thursday, May 24, 2001 8:27 PM
Subject: Difference between Starters
> Hello all,
>
> I am replacing the exhaust manifold with a header arangement for my 1970
> 1600. I was told that I need the 2000 starter and that it is shorter and
> fatter than the 1600 version. Now, I replaced the starter a year or so
back,
> but I am not sure which model starter went in then (not like Pep Boys knew
a
> whole lot - just this one will fit...and it did). So....
> Does anyone know the actual dimensions of the two (or at least the 2000
> model) so I could verify if the current starter is the right one or I have
to
> go shopping once more.
>
> Thanx
>
> Kevin
|