I'm about to test run an Eastwood powder coating kit for some of my parts.
Oven hooked up today in the garage...:):) ( Beer fridge MUST have some use
for a roadster restoration - no??) Reading through the instructions, it
seems like the powder "flows" at about 400 F. I'm not sure how it will
perform on an exhaust manifold - whether it is insensitive to temp after the
initial heat treatment. My 2 cent's worth...
Cheers...Michael
'68 1600
----- Original Message -----
From: "Hoon Kim" <hoon@pixar.com>
To: "datsun roadster mailist" <datsun-roadsters@autox.team.net>
Sent: May 16, 2001 6:29 PM
Subject: powder coating
> quick question.
>
> Is it worth powder coating an exhaust header? How much does it cost?
> I have a used header with surface rust that I'm going to install to
> replace my cracked exhaust manifold.
>
> Thanks.
> --
>
>
> Hoon Kim
> Pixar Animation Studios
> Emeryville, CA
> hoon@pixar.com
|