This might just be for early cars, dont know what they
look like on 68 and up. But, If you are rebuilding or
in any way have a reason to fool with your washer
nozzles, and the original gaskets are black
dust fragments....go to the hardware store and
get some kitchen sink valve seats. Hard rubber cone shaped
things...just match for the right size, I had to drill out
the hole in the center just a bit, but the nozzles now
sit on thes tapered hard black rubber gaskets that
look designed for the job, and cost 23cents each.
Taper goes up, flat side down, and looks sharp.
Yea, its a little thing, but just like about a thousand
other little things...........
Best Regards,
Jim C.
Chesapeake Va
67 pushrod 2L 5spd
72 1600 510 wagon
|