Ron Hamilton wrote:
> The pinion seal is at the front where the yoke from the drive line
> attaches and can be replaced without disturbing anything. In fact you can
> do it with the housing still on the car as it pops out towards you. The
> nut that holds the flange has some hefty torque and it is necessary as it
> is pre load for the pinion bearing .
>
> Ron
Ron,
Thanks for the quick response. I wasn't thinking that the seal would come
out without a complete dissasembly of the center section or disturbing any
setup. This is good news. I will fire up the air impact gun and zip off
that big nut.
Thanks
Bob
|