Nathan wrote:
> 1. The car will not idle slower than 1500 RPM...
> 2. Where are the vacuum lines supposed to be run? Currently I have the
> intake vacuum port running to the vacuum advance (distributor). The vacuum
> pod on the back of the front carb is capped.
If you've got the distributor vacuum advance plugged into a source
of manifold vacuum (15-20 in Hg), that's a major problem. You'll
find your timing WAY advanced, and advancing the timing speeds up
the engine. Try pulling the hose (plug the manifold tap with your finger),
and I suspect the speed will drop way back down.
Vacuum for the distributor needs to come off a port that is ZERO at
idle and INCREASES with opening the throttle - and that's what the little
fitting on the front carb (under the rear carb for a 1600) is for. I
suspect you're plugged into the smog 'burp valve' fitting right now.
Either that, or you're misconfigured with the overheat vacuum switch
that's part of the smog package (3-port vacuum switch on thermostat,
connects distributor, vacuum advance carb port, and manifold vacuum).
-- John
John F Sandhoff sandhoff@csus.edu Sacramento, CA
**************************
This Message has been resent by the Knick.Net EMail Admin System.
|