On mine it goes to the middle connector on the side of the fuse block that has
three connectors. The heavy white wire goes to the same connector.
Steve Allen wrote:
> Hello All,
>
> I am putting the electrical back into my 67.5 pushrod 2 liter. I have one
> solid black wire that goes to the new fuse block and I am unsure of where
> it goes. I have the wiring diagram for the 2000/1600 67.5 but this spare
> solid black wire does not show up or if it does I am blinded from looking
> at the fine print on the wiring diagram. Can anyone give me a clue? It
> comes out of the stock wiring harness so it is not someones add on. I had
> all the wires marked but when I cleaned up the wiring harness this one lost
> its tag. I hate it when that happens. All the others are good to go except
> for this one wire. I would hate to hook it up to the wrong terminal and fry
> something.
>
> On another note, there was a thread a while ago looking for alternatives
> for the rubber cowl vent hose. They are either deteriorated or darn hard to
> find. I found an alternative and it works
> great. I bought some 1-1/4" corrugated sump pump hose from Orchard Supply a
> local hardware store. It fits through the rubber grommet in the firewall
> very tightly and the corrugations provide just enough bend to shape the fit
> to very close to the original. I did not want to simply plug up the hole to
> let it drain down the inner sides of the fenders. It is not OEM but it
> definitely works, looks good, and should last quite a while under the hood.
> I had to buy a 20 foot length and only used around 2-1/2 feet. If anyone
> wants to try it, send me an address and I will ship it to you for the cost
> of postage.
>
> Steve Allen
> 67.5 2 liter pushrod
> R.P. CA
>
>
--
Gordon Glasgow
http://www.gordon-glasgow.org
|