Good evening All.
I have a question.
What should the measurement from the top of a flat top
piston to the deck be? Im just trying to make sure I
dont wind up too low on the compression. I want to
have the machinist deck the block if necessary but Im
also going to have a thin head(a little above
minimum).
How do I guage this?
I appreciate the help as I finally have time to do
something again to the car! :) Though it wont make
Doheny, I will.
joshua milton
69 1600 <--not 1 bolt of the engine assembled.
encino, ca
=====
|