In a message dated 27-05-99 7:42:19 AM EST, bpatton@eastman.com writes:
<< My
gas gauge is WAY off scale. When the tank is slam full, it reads a bit under
half, and registers on down to "E". After stranding myself a couple of
times, my brain is now calibrated, but I'd like to correct this if possible.
Help?! >>
Hello,
I had the same problem with my gauge. I pulled the sender out of the tank
and noticed that there was something like a slide that could actually be
adjusted. Well, I fiddled with it and installed it and there was actually a
change in the reading of the gauge. It kept adjusting until it read full.
(Yes, the tank was actually full) ;>)
Bear in mind that you should do this outside and away from any heat sources.
Good luck and let me know how it turns out.
Michael "Calspeed" Carion
67.5 SRL311-000248 Solex
San Francisco, Ca / BADROC
|