Mine is already mounted as low on the slope of the floor as possible and the
rear braces bolt on the shelf in front of the rear shock cross member. I
had to cut away part of the hat channel under the shelf to clear two bolts.
Now what?
Paul
-----Original Message-----
From: Rob Robinson <FastrTime@T-Three.com>
To: Paul <9laser3@bright.net>; datsun-roadsters@autox.team.net
<datsun-roadsters@autox.team.net>
Date: Friday, May 07, 1999 6:25 PM
Subject: Re: Soft top VS roll bar!
>My Autopower bar will not clear the soft top either - if the bar is
>installed in the factory holes. I moved the bar forward about 3", placing
>the rear support mounts directly above the rear shock crossmember. The top
>clears the bar in this location.
>
>Rob Robinson
>CSP 67 2000
>Roanoke, Va
>
>----- Original Message -----
>From: Paul <9laser3@bright.net>
>To: <datsun-roadsters@autox.team.net>
>Sent: Friday, May 07, 1999 9:42 PM
>Subject: Soft top VS roll bar!
>
>
>> I just installed an AutoPower street roll bar this spring and now my
>soft
>> top frame won't clear the bar. The rear most loop, the adjustable one,
>hits
>> each side of the roll bar. Any ideas?
>>
>> Paul
>> 1969 1600
>> OROC
>>
>>
>
|