I've always
just checked the piston oversize number (stamped on the crown of the
piston) then ordered that size. I have, out of paranoia, always checked
end gap before intstalling, just to be sure. They've always been within
a thou or three...
Are Total Seal rings available for the roadster? If so, they'd be no
more expensive than Nissan rings, and they do seal a bit better.
Toby
Scott Calkins wrote:
>
> What is the best way to measure the size for a new set of rings. I have the
> head off the 1600 to get a needed valve job, and was gonna throw in a new
> set of rings while I was at it.
>
> Scott
|