In a message dated 12/15/02 3:31:00 PM Mountain Standard Time,
james_nazarian@excite.com writes:
> How, can I tell if the block was decked or if the head was shaved? Are
> there places to measure such things?
Any half reputable engine shop with the ability to do this work will stamp
the block on the head surface, usually top front, and stamp the heads on the
head surface in the same location. You should find a 005 or 010 indicating
the deck or skim.
Regards,
Glenn Merrell
President, Triumph Stag Club USA
<A HREF="http://www.triumphstagclub.org/";>http://www.triumphstagclub.org/</A>
<A HREF="mailto:StagbyTriumph@aol.com";>StagbyTriumph@aol.com</A>
***J*O*I*N**Y*O*U*R**T*R*I*U*M*P*H**C*L*U*B**T*O*D*A*Y*****
**Member of VTR, TSC, SOC
**7*3**S*T*A*G**x*2****************************************************
///
/// buick-rover-v8@autox.team.net mailing list
///
|