Buick 300 and P76 inlet manifolds

[Simon Pigot <simon@dpiwe.tas.gov.au>]

Anybody know whether the 1964 Buick 300 alloy inlet manifold is larger
(too much to hope for that they might be the same size) than the P76 V8
inlet? Might be easy to machine a little off the Buick 300 inlet in
order to use it with the P76 4.4....

Perhaps someone could contribute a top and bottom width and I can
compare this with the P76 inlet and post the results back here?

Thanks,
Simon

--
Simon Pigot                                             simon@dpiwe.tas.gov.au
GIS Unit, Parks and Wildlife Service,
Level 6, 134 Macquarie St,                              Ph: +61 3 62 338357
Hobart, Tasmania, Australia, 7001                       Fax: +61 3 62 332744

///
///  buick-rover-v8@autox.team.net mailing list
///