This is also detailed on one of their web site pages.
_________
| |
Jim Hearnden ___ _|_________|_ ___
| |(_) _______ (_)| |
Work 01732 224340 | |-O|| ||O-| |
Mobile 07930 353232|___|__||_______||__|___|
|___| \_________/ |___|
WESTFIELD
===================================
This email is confidential and intended solely for the use of the individual
to whom it is addressed. Any views or opinions presented are solely those of
the author and do not necessarily represent those of BT Syncordia Solutions
. If you are not the intended recipient, be advised that you have received
this email in error and that any use, dissemination, forwarding, printing,
or copying of this email is strictly prohibited.
-----Original Message-----
From: Barrie Robinson [mailto:barrier@bconnex.net]
Sent: 18 July 2000 17:43
To: The Becketts; William Parris
Cc: mgb-v8; buick-rover-v8
Subject: Re: high performance head gaskets for Buick/Rover V-8
Will,
I have checked with RPi Engineering and the guru, Chris Crane, says - yes
back-off the torque on outside bolts
At 08:34 PM 7/18/00 +1000, The Becketts wrote:
>Will Parris wrote:
>> I have just rebuild my motor Rover 3.5L and used the Fel-Pro blue
>> gaskets, and torqued the head as to the ROM specs, now what should I do
>> leave it or slack off the short bolts and retorque them to a lower
>> torque.
>
>
>Will, have you run the engine? If not I wonder if you could back the ALL
>off and retorque them? Otherwise, retorque just the outer row. Did you
>refer to the RPI site re blowby?
>
>Ron Beckett
>
>
Regards
Barrie Robinson
barrier@bconnex.net
|