Here's a detailed question about BOP 215 engine mounts. I have engine
mounts that have 15/32" holes for the bolts that go into block, but the
block bolt holes are only 3/8". This leaves 3/32" of slop between the
engine mount holes and the bolt. Doesn't seem right... Do I have the
wrong engine mounts? Or is there a bushing that's supposed to go
between the bolt and the mount? Or it there a special 3/8" bolt that
has a 15/32" shoulder?
Similarly, the engine mounts have tabs that bolt to the frame, and these
tabs have slots instead of holes. The slots are 15/32" wide by 11/16"
long. How are these supposed to work? I expected a hole?
Thanks,
Bill Wessale
|