I have a full set of urethane bushings for the suspension on the Midget.
I was fitting them together in the relavent places. They were a great
fit in the A arms, but a really crappy fit in the upper trunion link.
So what should I do??
Shave off the bushing or ream out the trunion link? I'm worried about
doing either as the suspension/steering geometry is very much dependent on
the correct alignment of these components. As I remember, the rubber
bushings were not a great fit in this link. Could it be a duff link or
maybe it was swaped with one from another car??
Does anyone have a spare 77 Midget link sitting around they would send
to see if it fits better?? It should be a good fit, if not something is
wrong, I'd rather correct the problem than start "making" them fit.
Cheers Dennis
|