british-cars
[Top] [All Lists]

Churchill hub puller

To: british-cars@hoosier.cs.utah.edu
Subject: Churchill hub puller
From: ian@Centric.COM (Ian Macky)
Date: Wed, 4 Nov 92 09:38:28 PST
The Churchill hub puller for TR6 is part# M86C.  It is NOT hydraulic, just
a normal screw-driven puller.  Bell-shaped body whose flat flange base bolts
to hub, bell part clears the shaft and such.  Top of bell is tapped and a
normal long threaded rod runs through it, butts up against the end of the
shaft which is what you push on.  They also provide a flange on the side of
the bell for a handle, to keep the whole mess from rotating when you try to
pull.

Nothing exotic, just a puller made specifically for that purpose.  As with
all pullers like this, you can drive them with an impact wrench if hand
power doesn't cut it.

--ian


<Prev in Thread] Current Thread [Next in Thread>
  • Churchill hub puller, Ian Macky <=