:: I have the spitfire 1500 frame with the extensions that bolt
:: to the trunk floor. Would this frame be compatible with the GT6+
:: rear end? In short, is it possible to bolt a GT6+ drive line into
:: a late spitfire frame? Also, I have the 1979/80 stlye slanted
:: radiator with an electric fan. Would this been sufficient to cooling,
:: the 6 cylinder or would that have to be changed too?
The engine, trans and diff will bolt in. The GT6+ rear axles with the rubber
donuts will NOT bolt in, unless you weld on lower A arm brackets. The radiator
will not fit, as it needs to be smaller, since the length of the 6 cylinder
not only dictates the bulge in the bonnet, but moving the radiator as far as
possible forward.
mjb.
|