since you have tried the obvious and not found the leak, simple paint
everything with the bubble solution, The entire regulator the entire tank
everything, then look for bubbles. you may find it is the lubricator or the
regulator, I personally don't run a lubricator, I just lube the cylinders
every spring with a quick squirt of AW32 in the upper port and call it done.
On 8/3/2009 11:27:32 PM, maycinc@cs.com wrote:
> John,
> The check valve is new and I put it in the control box. Next time I air
> up
> the system
> I'm going to take the line off the compressor side of the valve
> to see if the valve is actually working. I've
> also thought about
> disconnecting the line that goes to the tank and hook up a vacuum pump but
> I don't
> know if I could get a good enough seal on the fitting. I've
> also thought
> about removing the pressure gauge and water trap.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|