easiest and best thing to do is find a truck place local that makes
driveshaft's, They are not that expensive to be made, If yours is too long it
could be shortened if it is too short just have a new one made. You may be
able to spend 4 days in junkyards finding one that is close but in the end you
will be better off getting a new one, it should be under $200, just bring them
the transmission yoke and the measurement, ask them how they want the
measurement, some want end to end some want center to center of u joint.
On 7/7/2009 9:06:51 PM, Greg Schroeder (gschroeder@comcast.net) wrote:
> OK, I almost have the engine rebuild and the 700r4 transmission installed.
> I
> am just about 1/4 inch off of installing the motor mounts. I had to
> remove
> them to get the transmission past the firewall and removing these
> and
> installing them after the engine is installed it a real pain. It looks
> like I
> am going to be about three inches short on the drive shaft as I expected
> from
> comparing the Torque Command to the 700r4. What are my options to
> resolve
> this issue?
>
> Greg 0036
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|