bricklin
[Top] [All Lists]

RE: Side Molding

To: "'High Tech Coatings'" <rick@hightechcoatings.com>,
Subject: RE: Side Molding
From: "Early, Stephen" <Stephen.Early@mbna.com>
Date: Fri, 3 Dec 2004 13:08:10 -0500
Don,

Rick summed the replies up well.  I ended up getting the molding through
Bricklin Boyz.  You can contact them via email at wasteland1@rogers.com

Stephen I. Early 
Portfolio Conversions 
Technology Sector-MBNA America 
302.457.4788 
800.441.7048 x74788 
stephen.early@mbna.com 



-----Original Message-----
From: High Tech Coatings [mailto:rick@hightechcoatings.com]
Sent: Friday, December 03, 2004 12:44
To: bricklin@autox.team.net
Subject: Re: Side Molding


 I replied on the list but here goes again, I have some NOS of the newer
grained stuff, not a whole set, but some pieces. I told him to try bob or
terry, Others told him that body shop supply houses have some that is close,
it is about 1/8" narrower. Rich Haines in Ohio may have a set or 2 also.
Rick

----- Original Message ----- 
From: "blownh-d" <blownh-d@jymis.com>
To: "ZZ9" <bricklin@autox.team.net>
Sent: Friday, December 03, 2004 12:21 PM
Subject: Side Molding


> A couple days ago Stephen Early wrote a message to Bricklin@autox
> thanking people
> for all the replies regarding where to find the side molding.
>
> I too was interested in locating a resource for the molding and hoped to
> gain that info
> via answers to his request. It appears the requested info only went to
> Stephen and did
> not go to this forum for the rest of us to use in pursuit of our
> restorations.
>
> Please share this knowledge by sending info to Bricklin@autox, not the
> individual.
>
> Thanks,
> Don     #1880  #2745




<Prev in Thread] Current Thread [Next in Thread>