If the hood is not too bad and is mainly settling down too low below the line
of the fenders, you can get it to settle into shape by carefully adjusting
the height of the rubber knobs that the hood rests on. Do it a little at a
time over a few days if necessary so as not to crack the acrylic. The knobs
go at the corners of the hood and on the shock towers. Keep it inside and
protect from extreme temperatures.
George
> Also has any
> one found a way of " un-warping body pannels like the hoods?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/bricklin
|