bricklin
[Top] [All Lists]

Re: door wiring

To: jblair@exis.net, bricklin@autox.team.net
Subject: Re: door wiring
From: Maycinc@cs.com
Date: Tue, 22 May 2001 11:15:57 EDT
John,
My Brick's in the paint shop so I can't look at it but here are some 
possibilities...  There are 2 small (I think black) wires that come out of 
the roof (one on each side) that connect to the rear window defroster.  There 
is one (splits to 3 with eyelets) large #10 black wire that is a ground that 
goes from the frame in front of the gas tank, into the door control box, and 
connects to the 3 hydraulic solenoids.  I used this as a ground for the air 
module.  Don't forget the wires that go to the dome light switches.  Can't 
remember anything else.  I'll try and look the next time I go check on the 
progress of my Brick.
Marvin
#1343


In a message dated 5/20/2001 3:37:33 PM Mountain Daylight Time, 
jblair@exis.net writes:


> I was playing with the door wiring harness today.  There are 2 larger wires 
> coming put by the external door switches.  These wires are orange and black.
> The orange wire is for the door latch solenoid down in the door and has a
> connector that connects to the orange wire coming out of the door.  My
> question deals with the black wire.  I think they both had eyelets on them.
> Where do they connect?  The only thing I can think of is to the hatch hinge
> bolts.  Is this correct?
> 
> TIA
> 
> John

///
///  bricklin@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>