Ok, I just put all new pistons and all new everything in the engine to
#2568, got it all back and and it started the first time and ran smooth.
went to put it in drive to move it onto the rack to finish up the bottom and
it wouldn't move. I remembered it lost a lot of transmission fluid from the
cooler lines so I filled the transmission up and it still won't move. It is
actually shifting from drive its just not moving, I think the torque
converter may have been hit kinda hard putting the engine back in, but if
the torque converter was not in place the seal would be leaking. So I'm not
sure exactly whats wrong but I'll check it out in the morning. Anyone had
any problems like this before? I kinda hope the transmissions junk so I can
put a better transmission in. FMX's just really don't cut it that much.
Ryan #2568
_________________________________________________________________
///
/// bricklin@autox.team.net mailing list
///
|