Mail order: JEGS carries it at 1800 345 4545
about $20, will let you know if fit is good when I install it. The size
should allow the connector to pass thru, but you never know.
stephan 2821
----- Original Message -----
From: "John T. Blair" <jblair@exis.net>
To: "alfaki" <alfaki@bellsouth.net>
Cc: <Bricklin@autox.team.net>
Sent: Friday, June 02, 2000 8:45 PM
Subject: Re: Advisory: Speedo Cable
> At 10:57 AM 6/2/00 -0400, Stephan wrote:
>
> >On the 75's with a/t, the speedo cable is very close and above the
exhaust
> >pipes where the cable is going into the tranny on the driver's side of
the
> >vehicle. This position can cook the speedo cable and eventually cause it
to
> >fail.....
>
> >I'm installing 1.5"x 3' Thermo-Tec thermo sleeve p/n 14015 to protect
the
> >replacement cable. Just thought I'd share this with others so they can
> >avoid problems down the road.
>
> Stephan,
>
> Where did/do you get the Thermo-Tec sleeve from? I think the starter
> cable could benifit from this also. When I had my new starter cable made,
> the shop didn't have any type of heat shield.
>
> John
>
>
> John T. Blair WA4OHZ email: jblair@exis.net
> Va. Beach, Va Phone: (757) 495-8229
>
> 48 TR1800 48 #4 Midget 65 Morgan 4/4 Series V
> 75 Bricklin SV1 77 Spitfire 71 Saab Sonett III
>
> Morgan: www.team.net/www/morgan
> Bricklin: www.bricklin.org
>
|