I can't remember the number but Terry Tanner has a favorite and the p/n. It
was very reasonable and I believe it was a 2bbl. Unless you're doing
serious mods, this would probably be the way to go. No sense in pouring gas
down the tubes. As for the Tri-Ys, you may want to get them ceramic coated,
or wrap them. The ceramic will look nice and the headers will last longer,
the wrap may insulate from heat better.
stephan
> ( I have a 1975 bricklin ) I am going to replace my carb. and need some
> input. Is there a DIRECT
> relacement Holley carb I can use. ( I remember reading it here a while
back
> ) If so, what is the part # etc. Anybody use anthing other than a Holley
and
> how has it worked out. I am getting #2525 road ready again, and would like
to
> make a few mods before I start driving it again. Those headers sound like
the
> next thing I am going to get.....I am getting down to the wire and am
looking
> forward to getting behind the wheel.... Any help and or advise will be
> greatly appreciated.
>
> Mike
>
|