i looked for quite a while, finally found CASEY"S for the cranks, and hunter
for the blocks, just make sure they balance your rods and pistons, i used them
for 1500 triumphs, the last one i did was sold and driven from here to
brownsville texas with no problems
> To: Bmcu@autox.team.net
> Date: Wed, 27 May 2009 09:22:55 -0400
> From: davebudden@netscape.net
> Subject: [Bmcu] Any know of a good machine shop
>
> Hi everyone,
>
> Can anyone suggest a good machine shop? I have a '73 MBG GT I am rebuilding.
Is there a machine shop in the SLC area that is familiar with MG's?
> Thanks,
> Dave
> _______________________________________________
> Bmcu mailing list
> Bmcu@autox.team.net
> http://autox.team.net/mailman/listinfo/bmcu
_______________________________________________
Bmcu mailing list
Bmcu@autox.team.net
http://autox.team.net/mailman/listinfo/bmcu
|