ba-autox
[Top] [All Lists]

Re: classes

To: "John J. Stimson-III" <john@harlie.idsfa.net>, <davmil@attbi.com>
Subject: Re: classes
From: "Lolita Adrien" <lomike@earthlink.net>
Date: Mon, 21 Apr 2003 18:13:41 -0700
John, John,John. Where are your manners? You should have included a welcome
to the slippery slope;-)))
MJ
----- Original Message -----
From: "John J. Stimson-III" <john@harlie.idsfa.net>
To: <davmil@attbi.com>
Cc: <ba-autox@autox.team.net>
Sent: Monday, April 21, 2003 17:46 PM
Subject: Re: classes


> Roughly...
>
> Stock
> Street Touring (4 seaters only, see rules)
> Street Prepared
> Street Modified
> Prepared
> Modified
>
> There is a transcription of the classification rules online at
> http://www.moutons.org/sccasolo/
>
> On Tue, Apr 22, 2003 at 12:29:25AM +0000, davmil@attbi.com wrote:
> > I recently participated in the Mazda Revitup event. It rekindled
> > an interest in autocross for me. I used to run a Mark IV Sprite
> > and later a Mustang in the early 1970's. I was looking at the
> > car categories and found myself a little confused. I only remember
> > stock, prepared and modified and now there is street prepared,
> > street modified and several others. In which order, starting with
> > stock (from the least changes to the most) do the categories run.
> > I had to buy a new car a few months ago (my modified Honda Civic
> > hatch was stolen last year) and I would like to make a few changes.
> > I will probably only run it occasionally, however, and since I only
> > plan to modify it slightly, I want to make sure I don't make the
> > one change that will bump me into a category where I won't be able
> > to compete unless I make a lot more changes (I hope this makes
> > sense to someone). I want to run just above stock and if I know the
> > order, then I will be careful to choose the right mods.
> >
> > David
>
> --
>
> john@idsfa.net                                              John Stimson
> http://www.idsfa.net/~john/                              HMC Physics '94

<Prev in Thread] Current Thread [Next in Thread>