ba-autox
[Top] [All Lists]

RE: Street Mod - Rules regarding wings and hoods - a reply from

To: "Ba-Autox (E-mail)" <ba-autox@autox.team.net>
Subject: RE: Street Mod - Rules regarding wings and hoods - a reply from
From: "Mark Smith" <msmith@tilia.com>
Date: Mon, 14 Apr 2003 16:38:39 -0700
The reference to Section 14 is pertaining to fender flares only. Look at it 
again and I think you'll see what I mean. It allows hoods, etc. and then it 
takes it back by Section 14? I don't think so. It was to prevent people from 
replacing the rear fenders on a unibody car.

"Wings" is a plural word. I'd say you can run as many as you'd like and they 
can be multi-element.

Replacement hoods are allowed in SM. This is the intent of SM - to allow the 
"common" radical mods that people do to their cars.

If you just keep the Section 14 reference attached to fender flares, I think 
you'll see it differently.

Hope this helps.

Doug Gill
SCCA Solo Technical Manager


-----Original Message-----
From: Mark Smith 
Sent: Monday, April 14, 2003 2:49 PM
To: Ba-Autox (E-mail)
Subject: Street Mod - Rules regarding wings and hoods.


With the rules for Street Mod (and SM2) being rather open - I thought that I'd 
post this question up here just incase anyone can clarify this - before I go 
away and spend my money :)

Wings:

18.1.G The firewall, roof, doors, rear quarter panels, floor pan, trunk lid (if 
any) or rear hatch (if any) must remain stock. Holes may be drilled to allow 
attachment of body kits, etc. This specifically allows replacement hoods, 
fenders, wings, front & rear fascias, side skirts, and fender flares as per 
Section 14  Body panels may be attached with removable (e.g., Dzus) fasteners. 
18.1.J Wings may only be attached to the rear deck/hatch area and may not 
extend more than six inches beyond the widest part of the bodywork on either 
side.

As Section 14 (Street Prepared) does not allow aftermarket wings does these 
mean than in SM aftermarket wings are also not allowed  - or does 18.1.J 
"trump" this to allow wings? Can a competitor run any wing configuration as 
long as it meets the "not more than six inches beyond the bodywork" rule?

Hood: As Section 14.2 does not permit complete replacement hoods (as of 9/2002) 
Would I be right in saying that this is also the case in SM.
I'd normally would have sent this off to Howard Duncan - but I hear he's a 
little swamped these days.
Any help would be appreciated.
Thanks,

Mark.

<Prev in Thread] Current Thread [Next in Thread>
  • RE: Street Mod - Rules regarding wings and hoods - a reply from, Mark Smith <=