I also had DentPro remove the dents and crease from the timing lights
at the SFR/Sac Mather event last year. It wasn't perfect, but it was
an improvement. The problem, according to the tech, was that part of
the dent was in/near a concave part of the door panel, and pressing
too hard to pop out the dent would pop out the whole section of the
door. I think the cost was around $120 for that set of dents. I
don't know if it was Brad who did the work, or if perhaps I should
call them again and ask for him.
Peter, you can come look at the door if you don't remember what it
looks like.
--
john@idsfa.net John Stimson
http://www.idsfa.net/~john/ HMC Physics '94
|