Just a few minor comments on Darren's most totally excellent post...
At 08:53 AM 8/29/00 -0700, Darren P. Madams wrote:
>There are plugs on the back for the start and stop triggers, as well as at
>least one for the display. There is a power switch back there too.
The only thing that you need to touch on the back of the timer is the power
switch. The start and finish triggers and the displays should be plugged
in to the plugs that are installed on the side of the motorhome, under the
hatch.
One additional thing to be aware of - if the generator is on, check the
light on top of the black wall wart that powers the timer. If the light is
off, make sure the wall wart is firmly plugged into the power strip, and
that the power strip is turned on. The timer does have a battery that it
runs off of, but the battery only lasts so long, and may run out
unexpectedly...
>You will hear a single beep whenever somebody trips either the start or
>finish light. That is OK.
Tony's right - there is a single beep for each start, and a double-beep for
each finish.
Good job, Darren!
Jim Ochi
jochi@liquidaudio.com
|