Thanks Dennis. That's the same answer that Ground Control gave me when I
asked them about the problem (because I run their camber plates).
$20 is a no-brainer, even for a cheap Neanderthal like me.
Eric
----- Original Message -----
> There is another solution though that gets you about halfway to the full
on
> Hypercoil setup. If you get a set of radial needle thrust bearings (from
> your local bearing supply house) and place them between the spring and the
> perch, you allow the spring to rotate relative to the perches as it
> compresses/extends, and you take up some of the unwanted forces. It's not
> as good as the Hypercoil setup, but it helps.
>
> These bearings run about $10 each.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
|