I use one on my stock height S2000 - the only part that's too high is the
knurled knob that is used to secure the pole. I need to replace that with
one that takes an Allen wrench and it'll go under fine. I get around it now
by driving up on a couple of 2"x6" planks.
Etgar
-----Original Message-----
From: owner-autox@autox.team.net [mailto:owner-autox@autox.team.net]On
Behalf Of Eric Salem
Sent: Saturday, February 02, 2002 11:58 PM
To: autox@autox.team.net
Subject: RE: 2 pump jack
The Griot jack is low enough to fit under my lowered 911 when the slicks
are on. . . Not under the front spoiler but it still gets in there
pretty well.
Damn expensive, but I bought it off Ebay. :)
-----Original Message-----
From: owner-autox@autox.team.net [mailto:owner-autox@autox.team.net] On
Behalf Of Gary Spray
Sent: Saturday, February 02, 2002 10:52 PM
To: autox@autox.team.net
Subject: Re: 2 pump jack
At 10:38 PM 2/2/2002 -0800, Greg Reno wrote:
>Not bad Gary, but if we're looking at expensive jacks, I like aluminum!
>http://www.griotsgarage.com/catalog.jsp?&SKU=77744
Yes but the jack at Griots is not low profile and so would not fit far
enough under the front end to reach the cross member used to jack up my
Miata. If you are going to jack a car up from the side, any old jack
will do.
I guess I'll be using my cheapo Autozone jack for a few more years...<G>
_______________
Gary Spray
90 Mazda Miata
Topeka, Kansas
[More power is good, better handling is "gooder".]
/// unsubscribe/change address requests to majordomo@autox.team.net or
try /// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
|