autox
[Top] [All Lists]

FS: KONI Sports Bolt-in Front Strut Assemblies

To: "Team.net" <autox@autox.team.net>,
Subject: FS: KONI Sports Bolt-in Front Strut Assemblies
From: "Mark Chiles" <mark@markchiles.com>
Date: Fri, 25 Jan 2002 23:02:39 -0500
For Sale:

Left Front and Right Front Complete Bolt-in Front Strut Assemblies with KONI
Sport Strut Inserts (Koni Part # 86-2463)

These hydraulic KONI Sport strut inserts are adjustable off the car and new,
they will cost at least $125 each, ($250 for the pair).  And that is just
for the inserts.

These assemblies are complete with OEM strut housings (modifed to accept
KONI inserts), Uncut OEM SE-R springs (2 Green Dots and 1 White Dot) and old
style metal (not plastic) Thrust Bearings and new body/strut Gaskets.

Because these struts are hydraulic, not gas pressurized, when installed, the
car may become lower by a fraction of an inch.

These are standard, off-the-shelf, KONI inserts, bought from KONI a few
years ago.  These are not ProPart specials.

These will only require 10-15 minute to install.  NO SPRING COMPRESSOR
REQUIRED

Just jack up the front of the car, remove the clasp holding the brake line.
Remove the two clevis bolts and the three top bolts and slide out the old
assembly and slide in the new assembly and reattach.

If you would like to see a picture of the struts, open attachment below.

These were used on my '91 Nissan Sentra SE-R.   They should fit all other
'91 - '94 B13 Sentra.

$300 for the pair, packed and shipped to a 48 states address.

Can accept payment by credit card via www.paypal.com.

Mark Chiles

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Partial archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>
  • FS: KONI Sports Bolt-in Front Strut Assemblies, Mark Chiles <=