Which cam did Jim E recommend?
I am currently using a Holbay head with a stock cam <long story> and will
swap cams this spring I hope.
On a dyno, my stock cam has a power band from ~2K to a little past 5K, not
bad for average street use; by 5.5 it is all done. Revving to the 'red line'
is a waste of time. <sounds pretty good though>
I'd like to find a cam that will take advangage of the Holbay head from low
in the rpm range to high, maybe to 5.5 -- 6K - but also will build more
power than the stock cam, not just change the power band...
Coltec, the firm that used to be Holbay in UK offers a cam <E78 I vaguely
recall but an unsure without my notes>, but it kicks in at about 3K rpm, not
too good for rally/street use.
So I wondered which cam you were going to use.
Allan
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|