Cole,
Alignment (toe-in or toe-out) would cause excess tyre wear, but not pulling
to one side under braking.
Your problem will be, in order of probability, either:
1. Seized front calliper, due to corrosion of a piston. This causes bias to
one side as the piston does not move as required in its cylinder, on the
ineffective side.
2. Brake hose to calliper blocked. This is due to deterioration of the inside
of the brake hose. After 40 years or so, it's a good idea to replace these.
I'd recommend braided type hoses, available from most Brit car suppliers.
3. Seized rear drum. This is the most unlikely, if the pulling to one side is
that obvious.
Good luck,
Julian - Series III.
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|