> Was it on the digest that somebody was asking about the small ball
> bearing
> in the accelerator pump? I think they thought they had lost it or
> something but there might
> be another reason they don't have the ball....
>
> I have one set of carbs which the accelerator pump ball bearing is
> located within screw which holds down the discharge nozzle. Somebody
> had drilled out the screw, dropped the ball in, then used a piece of
> brass rod
> to cap the hole in the top of the screw.
>
> Was this a version that was stock or did somebody do this afterwards?
> Has anybody else run into this setup??? It is really nice being that
> you can't loose the
> ball.
>
> Steve
|