I seem to remember a discussion awhile back about the oil pump to block
fitment not being very good and some kind of sealant there would help
tremendously. Is this true?
Ray Frazier
----- Original Message -----
From: "Jarrid Gross" <JGross@econolite.com>
To: "chuck nicodemus" <armorseal@spiretech.com>
Cc: "Steven Silverstein" <milano164@mediaone.net>; "Sunbeam"
<alpines@autox.team.net>
Sent: Wednesday, August 22, 2001 10:58 AM
Subject: RE: Presure relief valve modification
> Chuck wrote,
>
> >Jarrid , you make some very good points, and I especially like the idea
of
> the
> >spray tube?? That would probably give you a few more pounds , but would
it
> be
> >significantly more?
>
> I'd say yes. The spray tube is right off the main oil supply, and the
> diameter
> of the hole at the end is large enough to be of some concern.
>
> To me, its a matter of finding all the places where the oil is lost,
> but without gain. There are other places where oil is lost where the
> gain is small, we'll get into these another time.
>
>
> Jarrid
|