alpines
[Top] [All Lists]

RE: Weber help

To: mbgardner <mbgardner@core.com>, alpines@autox.team.net
Subject: RE: Weber help
From: Jarrid Gross <JGross@econolite.com>
Date: Fri, 3 Aug 2001 15:31:51 -0700
MBGardner wrote,

>Would anybody on the list know if Weber made a carburetor with Motorcraft
on
>it w/ a stamped #R6503 on the base and a circle 26 and 27, respectively on
>each barrel, and an A# in the middle of the casting that would fit a SV
>motor?


Sort of,

Motorcraft bought holley 5200 carbs, then put thier name
on them.  The holley 5200 is a licensed copy of a weber DGEV
progressive 2bbl carburettor.

The 26 and 27 relate to the choke "venturi" cross
sectional diam.  This would most likely be a 32/36 carb
used on a 2000 or 2300 pinto engine.

Later carbs (79 and later) used a emmisions feedback mechanism,
which has several wires comming out of the case.  These should 
be avoided like the plague.

Jarrid Gross


-----Original Message-----
From: owner-alpines@autox.team.net
[mailto:owner-alpines@autox.team.net]On Behalf Of mbgardner
Sent: Friday, August 03, 2001 2:47 PM
To: alpines@autox.team.net
Subject: Weber help


Would anybody on the list know if Weber made a carburetor with Motorcraft on
it w/ a stamped #R6503 on the base and a circle 26 and 27, respectively on
each barrel, and an A# in the middle of the casting that would fit a SV
motor?

<Prev in Thread] Current Thread [Next in Thread>
  • Weber help, mbgardner
    • RE: Weber help, Jarrid Gross <=