Frank, Martha's kit includes the carpet strip you mentioned, and it was
original on the MKI. The step down from the front floor to the floor
under the seat, had vinyl on that portion.
BTW, the kit I have had the hole for the dipper cut 2.5-3" too high. I
called Martha today, but have not heard from her yet. I took 3 weeks
before I received a return call from my 4 calls to her. She said she
was out of town.
Have you figured out where those little triangular pieces go? She said
they go on the side portion of the parcel shelf, just behind the hinge
for the rear door on the MKI.
Wait till you get to the side strips, below the sill. Lots of extra
material, and you have to cut and fit, hopefully in the right places.
Doing mine now.
Good luck.
Larry
Frank Marrone wrote:
>
> Hi,
>
> I've started installing the carpet in my Tiger and I had a question about
> the driveshaft tunnel covering. I know that the tunnel under the center
> consul was originally covered with vinyl. What about the portion of the
> tunnel directly under the ash tray of the consul? I'm talking about the
> part of that stiffener ridge that runs across the floorpan (near the front
> of the seat rails) that rides over the tunnel. The carpet kit I have
> includes a piece of carpet for the horizontal portion of the ridge that
> crosses the tunnel but the vertical surfaces of the ridge will be exposed as
> far as I can tell using just the pieces in my carpet kit. Is there supposed
> to be vinyl covering the portion of the tunnel I've tried to describe?
>
> Thanks!
>
> Frank Marrone
> Turin Networks
> fmarrone@turinnetworks.com
> 707 665 4414
|