On Tue, 12 Oct 2010, michael lunsford wrote:
> Dave,
>
> When replacing the hubs don't forget that the torque for those hub nuts
> is very
> low-see the book for torque specs. This comes from someone who
> didn't check way
> back when and lived to regret it.
it's 10-12 ft/lb
use a 3/8" drive torque wrench. Most of the 1/2" drive wrenches don't
have a scale that works in the proper range.
get this wrong and the studs pull out.
:-(
> Mike Lunsford, 1970 TR6
regards,
rml
---------------------------------------------------------------------------
Bob Lang Triumph TR6!! | This space for rent
2010 NER Solo Chair |
Voice:617-253-7438 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|