With the recent thread on the 6 pack email list, I have a couple of
questions for the wisdom of the collective groups.
Just installed a triple stromberg (Good setup) on a rebuilt early TR6
engine with a cam this past fall. The only problem I have is during
starting, it takes more than two carbs to start the beast. I need a
third cable to connect to the center carb to get it going. after that it
runs to problem.
Any one else had this issue? I have the front and rear carbs on the
cable. The center carb is not contributing to the starting event.
All three carbs were extensively rebuilt including throttle shafts and
seals.
Any ideas out there??
Thanks in advance
Glenn Franco
3 TR6's , TR250, Spit race car and a nice 76 rust free spit.
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|