On Fri, 18 Sep 2009, michael lunsford wrote:
> Al,
>
> You didn't describe the symptoms so I'll just throw out a WAG.
> Any
> chance that the clutch has rusted to the flywheel? I doubt this could happen
> if the flywheel is aluminum. One of our club members recently had a similar
> problem, replaced the clutch and then found out rust was the problem. Good
> luck.
This _could_ happen as the clutch surface on the Fidanza flywheel is a
steel insert.
I replied off-list that my guess is that the clutch disk was not installed
in the proper orientation.
> Mike Lunsford, 1970 TR 6
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2009 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|